Sony SCD-XA9000ES - Manual (Page 23)

Playing Discs
23 US
Creating Your Own
Program
(Program Play) Z
You can pick out the tracks that you like and specify the
playback order in a program containing up to 32 tracks
(or 999 min. 59 sec. in total program time)
1 Press PROGRAM in stop mode.
“Program” appears in the display.
2
Press the number buttons to enter the track
number.
If you entered the wrong track number
Press CLEAR to erase the track number and reenter
the correct track number using the number buttons.
To select a track number over 11
Press >10 (page 20).
3
Repeat step 2 to enter other tracks.
Each time you enter a track number, the total
program time appears in the display.
4
Press H.
Program Play starts.
To resume normal play
Press CONTINUE.
z
The program remains even after Program Play ends
Press H to play from the beginning of the program again.
The program remains even if you stop play.
Note
If you turn off the player, disconnect the mains lead, press
A
OPEN/CLOSE, or change the playback area (2 channel/
mulch channel) or layer (CD/HD) of the Super Audio CD (page
15), the program will be erased.
Checking the contents of the program
Before you start playing or while the player is playing,
press CHECK.
Each time you press the button, the track numbers will
appear in the display in the programed order.
When you press CHECK while the player is playing, the
track number appears from the next track numbers of the
current playing track number.
Changing the contents of the program
You can change the contents of the program in stop mode.
To
Erase a track
Erase from the last
track in the program
Add a track to the
end of the program
Erase all tracks
Do the following:
1 Press CHECK repeatedly until the track
number you want to erase appears.
2 Press CLEAR.
Press CLEAR.
Each time you press the button, the last
track of the program is erased.
Press ./> to select the track you want
to add, then press PROGRAM. When using
the remote, press the number button of the
track to be added.
Hold down CLEAR or x (for about 2
seconds) until ”Prog CLEAR“ appears in
the display.
CLEAR
CONTINUE
Number
buttons
H
>10
PROGRAM
CHECK
. />