TransferJet is a close-up, wireless transfer technology that allows data to be transferred by
closely aligning two products that you want to communicate with each other.
To find out whether your camera is equipped with the TransferJet function, check for the
(TransferJet) mark on the bottom of the camera.
Using a Memory Stick with TransferJet (sold separately) allows images to be transferred
between TransferJet-compatible devices.
For more details on TransferJet, see the operating instructions supplied with Memory Stick with
TransferJet.

1. Insert a Memory Stick with TransferJet into the camera.
2. Press the

(Playback) button to switch to playback mode.

3. MENU

(Send by TransferJet)

desired mode

4. Transfer images by closely aligning the (TransferJet) marks on the camera and other

device.
A notification sound is emitted when connection is made.

(This Image)

Sends the currently displayed image in single-image mode.

(Multiple Images)

You can select and send multiple images.

After step 3, perform the following.

Select an image to be sent, then touch it.

Repeat the above steps until there are no more images to be sent.
Touch an image with a

mark again to release the

mark.

Touch [OK]

[OK].

Notes

Only still images can be transferred.
Up to 10 images can be transferred at once. However, for 3D images, both the MPO file
and the JPEG file are transferred. Depending on the receiving device, up to 20 images are
received.
Set [TransferJet] to [On] in

(Settings).

[Details]

On an airplane, set [TransferJet] to [Off] in

(Settings)

[Details]

. In addition, follow the

rules of the place where you use.
The connection is cut if transfer cannot be made within about 30 seconds. If this happens,
select [Yes] and realign the two

(TransferJet) marks on the camera and another device.

Memory Stick with TransferJet and camera models with TransferJet are not sold in some

157

Advertising

This manual is related to the following products:

DSC-TX100V

Popular Brands

Popular manuals