Sony STR-DH520 - Manual (Page 34)

34 GB
D:\NORM'S JOB\SONY HA\SO120020\STR-DH520_PMRF
02\4263361112_GB\GB04CON_STR-DH520-U2.fm masterpage: Left
STR-DH520
4-263-361-11(2)
When error codes appear
1 Check the problem of the error.
* xxx represent a speaker channel
F Front
S Surround
SB Surround back
FH Front high
Depending on the error code, the speaker
channel may not appears.
2 Perform Auto Calibration again.
Press
. “RETRY Y” will appears on the
display panel, then press .
3 Repeat steps in “3: Confirming/saving
the measurement results” (page 33).
If a warning on the measurement result is
present, detailed information is displayed.
* xxx represent a speaker channel
FL Front left
FR Front right
CNT Center
SL Surround left
SR Surround right
SBL Surround back left
SBR Surround back right
LH Front left high
RH Front right high
SW Subwoofer
Depending on the measurement result, the speaker
channel may not appears.
To return to step 2 of
“3: Confirming/saving the
measurement results”
Press .
Tip
Depending on the position of the subwoofer, the
measurement results may vary. However, there will
be no problems even if you continue to use the
receiver with that value.
Display and explanation
E - xxx * 32
None of the speakers were detected. Make sure
that the optimizer microphone is connected
properly and perform the Auto Calibration
again. If the optimizer microphone is connected
properly but the error code still appears, the
optimizer microphone cable may be damaged.
E - xxx * 33
• None of the front speakers are connected or
only one front speaker is connected.
• The optimizer microphone is not connected.
• Either the left or right surround speakers is not
connected.
• Surround back speakers or front high speakers
are connected even though surround speakers
are not meant to be connected. Connect the
surround speaker(s) to the SPEAKERS
SURROUND terminals.
The surround back speaker is connected only
to the SPEAKERS SURROUND BACK/
FRONT HIGH R terminals. When you
connect only one surround back speaker,
connect it to the SPEAKERS SURROUND
BACK/FRONT HIGH L terminals.
• Either the front left high or front right high
speaker is not connected.
Checking the warning message
Display and explanation
W - xxx * 40
The measurement process has completed with high
noise level detection. You may be able to achieve
better results if you try in a quiet environment again.
W - xxx * 41
W - xxx * 42
The input from the microphone is too big. The
distance between the speaker and the microphone
may be too close. Set them apart and perform the
measurement again.
W - xxx * 43
The distance and position of a subwoofer cannot be
detected. This may be caused by noise. Try to
perform the measurement in a quiet environment.
NO WARN
There is no warning information.