Sony STR-DH520 - Manual (Page 64)

64 GB
D:\NORM'S JOB\SONY HA\SO120020\STR-DH520_PMRF
02\4263361112_GB\GB09REM_STR-DH520-U2.fm masterpage: Left
STR-DH520
4-263-361-11(2)
Troubleshooting
If you experience any of the following
difficulties while using the receiver, use this
troubleshooting guide to help you remedy the
problem. Should any problem persist, consult
your nearest Sony dealer. Note that if service
personnel changes some parts during repair,
these parts may be retained.
The receiver is turned off
automatically.
• “AUTO.STBY” is set to “STBY ON”
(page 60).
• The Sleep Timer function is working
(page 13).
Dolby Digital or DTS multi channel
sound is not reproduced.
• Check that the DVD, etc. you are playing
is recorded in Dolby Digital or DTS
format.
• When connecting the DVD player, etc., to
the digital input jacks of this receiver,
make sure the digital audio output setting
of the connected equipment is available.
• Set “AUDIO.OUT” to “AMP” in the
HDMI menu.
The surround effect cannot be
obtained.
• Make sure you have selected the sound
field for movie or music mode (page 43).
• Sound fields do not function when DTS-
HD Master Audio, DTS-HD High
Resolution Audio or Dolby TrueHD with
sampling frequency of more than 48 kHz
are being received.
There is no sound, or only a very low-
level sound is heard from specific
speakers.
• Connect a pair of headphones to the
PHONES jack to verify that sound is
output from the headphones. If only one
channel is output from the headphones, the
equipment may not be connected to the
receiver correctly. Check that all the cords
are fully inserted into the jacks on both the
receiver and the equipment. If both
channels are output from the headphones,
the front speaker may not be connected to
the receiver correctly. Check the
connection of the front speaker which is
not outputting any sound.
• Make sure you have connected to both the
L and R jacks of an analog equipment,
analog equipment requires both L and R
jack connections. Use an audio cord (not
supplied).
• Check that the speaker settings are
appropriate for the setup using the AUTO
CAL menu* or “PATTERN” in the
SPEAKER menu. Then check that sound
is output from each speaker correctly,
using “T. TONE” in the LEVEL menu
(page 35).
• Adjust the speaker level (page 54).
• Check that the subwoofer is connected
correctly and securely.
• Make sure you have turned on your
subwoofer.
• Depending on the selected sound field, no
sound will be available from the
subwoofer.
• When all speakers are set to “LARGE”
and “NEO6 CIN” or “NEO6 MUS” is
selected, there is no sound from the
subwoofer.
• Some discs have no Dolby Digital
Surround EX flag even though the
packages have Dolby Digital Surround EX
logos.
*Europe, Australia and Taiwan models only.
Power
Sound