Sony STR-DH520 - Manual (Page 40)

40 GB
D:\NORM'S JOB\SONY HA\SO120020\STR-DH520_PMRF 02\4263361112_GB\GB05BAS_STR-
DH520-U2.fm masterpage: Left
STR-DH520
4-263-361-11(2)
You can enter the frequency of a station
directly by using the numeric buttons.
1
Press TUNER repeatedly to
select the FM or AM band.
You can also use INPUT SELECTOR on
the receiver.
2
Press D.TUNING.
3
Hold down SHIFT, then press
the numeric buttons to enter
the frequency.
Example 1: FM 102.50 MHz
• USA and Canada models only:
Select 1 b 0 b 2 b 5
• Other models:
Select 1 b 0 b 2 b 5 b 0
Example 2: AM 1,350 kHz
Select 1
b 3 b 5 b 0
Tip
Adjust the direction of the AM loop antenna
(aerial) for optimum reception upon tuning to
an AM station.
4
Press .
If you cannot tune to a station
Make sure you have entered the right
frequency. Try repeating steps 2 to 4. If you
still cannot tune to a station, the frequency
may not be in use in your area.
(USA and Canada models only)
You can change the AM tuning scale to either
9 kHz or 10 kHz using the buttons on the
receiver.
1
Press ?/1 to turn off the
receiver.
2
While holding down TUNING
MODE, press ?/1.
3
Change the current AM tuning
scale to 9 kHz (or 10 kHz).
To reset the scale to 10 kHz (or 9 kHz),
repeat the procedure above.
Note
All preset stations will be erased when you change
the tuning scale.
Tuning to a station directly
(Direct Tuning) Changing the AM tuning scale
?/1
TUNING MODE