Sony STR-DA5700ES - Manual (Page 149)

149 US
Ad
d
ition
al In
fo
rm
atio
n
Reference sections
To clear the memory of the
simple remote control
After removing the batteries, do not use the
remote control for a few minutes.
If the buttons on the receiver or the remote
control do not work due to a malfunction of the
receiver, reboot the receiver.
Hold down ?/1 for 10 seconds.
When the lamp above ?/1 flashes in green, the
reboot starts.
Refer to the following web site for details of
the latest information on the receiver.
http://www.sony.com/essupport
Specifications
AUDIO POWER
SPECIFICATIONS
POWER OUTPUT AND TOTAL
HARMONIC DISTORTION:
With 8 ohm loads, both channels driven, from
20 – 20,000 Hz; rated 130 watts per channel
minimum RMS power, with no more than
0.09% total harmonic distortion from 250
milliwatts to rated output.
Amplifier section
POWER OUTPUT
1) 2)
Rated Power Output at Stereo Mode
(8 ohms 20 Hz – 20 kHz,
THD 0.09%):
130 W + 130 W
Reference Power Output at Stereo Mode
(4 ohms 20 Hz – 20 kHz,
THD 0.15%):
130 W + 130 W
Reference Power Output
(8 ohms 1 kHz, THD 0.7%)
FRONT:
140 W + 140 W
CENTER: 140 W
SURROUND:
140 W + 140 W
SURROUND BACK:
140 W + 140 W
Reference Power Output
(4 ohms 1 kHz, THD 0.7%)
FRONT:
130 W + 130 W
CENTER: 130 W
SURROUND:
130 W + 130 W
SURROUND BACK:
130 W + 130 W
1)
Measured under the following conditions:
Power requirements: 120 V AC, 60 Hz
2)
Depending on the sound field settings and the
source, there may be no sound output.
Clearing the memory
To clear See
All memorized settings page 48
Memory of the multifunction
remote control page 135
Rebooting the receiver
About support information
continued