Sony STR-DA5700ES - Manual (Page 95)

95 US
U
s
ing O
th
e
r
Fe
ature
s
You can record with an audio equipment using
the receiver. Refer to the operating instructions
supplied with your MD deck or tape deck.
1
Select “Listen” from the home
menu, then press
.
2
Select the playback equipment,
then press
.
3
Prepare the playback
equipment for playing.
For example, insert a CD into the CD
player.
4
Prepare the recording
equipment.
Insert a blank MD or tape into the
recording deck and adjust the recording
volume level.
5
Start recording on the
recording deck, then start the
playback equipment.
Switching the command
mode of the receiver and
the remote control
You can switch the command mode
(COMMAND MODE AV1 or COMMAND
MODE AV2) of the receiver and the remote
control.
Switch the command mode from the factory
default setting to the appropriate setting, if
other Sony equipment is operated accidentally
by the same remote control, when you are
operating the receiver using the remote control
supplied with the receiver.
The command modes of both the receiver and
the remote control are those of the factory
default setting (COMMAND MODE AV2).
The receiver and the remote control, on the
contrary, should use the same command mode.
If the command modes of the receiver and the
remote control are different, you cannot use
the remote control to operate the receiver.
1
Press ?/1 to turn off the
receiver.
2
While holding down 2CH/
A.DIRECT, press ?/1 to turn on
the receiver.
When the command mode is set to “AV2,”
“COMMAND MODE [AV2]” appears on
the display.
When the command mode is set to “AV1,”
“COMMAND MODE [AV1]” appears on
the display.
Recording with an audio
equipment
Switching the command mode of
the receiver
2CH/A.DIRECT ?/1