Sony PEG-TG50 - Manual (Page 13)

13
My C
L
IÉ han
d
h
e
ld is
not w
o
rk
in
g
pr
operly
Symptoms and Solutions
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
My CLIÉ handheld is not working
properly
I cannot turn on my CLIÉ handheld
B The POWER/HOLD switch of your CLIÉ handheld is in the HOLD mode.
Your CLIÉ handheld does not operate when the POWER/HOLD switch
is in the HOLD mode. Make sure you release the HOLD mode.
B The battery of your CLIÉ handheld has run out.
Place your CLIÉ handheld in the cradle connected to the AC adapter, then
charge it for a few minutes before turning it on. If it turns on, continue
charging it for approximately five hours and then perform a soft reset.
B The connector between your CLIÉ handheld and the cradle is dirty.
You cannot recharge your CLIÉ handheld if the connector is dirty. Try
re-installing your CLIÉ handheld several times in the cradle to clean the
connector.
I cannot see anything on the screen although the CHG LED
is on
B The POWER/HOLD switch of your CLIÉ handheld is in the HOLD mode.
The screen is not displayed when the POWER/HOLD switch is in the
HOLD mode.
B Perform a soft reset by pressing the reset button.
b For details, refer to “Basic operations of your Sony CLIÉ™ handheld: Restarting
your Sony CLIÉ handheld” in the “Read This First (Operating Instructions).”
My CLIÉ handheld is not responding
B The POWER/HOLD switch of your CLIÉ handheld is in the HOLD mode.
Your CLIÉ handheld does not operate when the POWER/HOLD switch
is in the HOLD mode. Make sure you release the HOLD mode.
Continued on next page
• • • • • • • • • • • • • • • • • • • •