Sony PEG-TG50 - Manual (Page 15)

15
My C
L
IÉ han
d
h
e
ld is
not w
o
rk
in
g
pr
operly
The backlight does not turn on when I adjust the
brightness level
B If the brightness is set to the lowest level, the display may be illegible, but
this is not a malfunction.
Tip
You can adjust the brightness level in the Adjust Brightness screen displayed by pressing the
Q key while pressing the
(red) key on the hardware keyboard.
I can’t read the screen properly
B Depending upon the angle of vision, the brightness may be uneven, but this
is not a malfunction. You can adjust the brightness level in the Adjust
Brightness screen displayed by pressing the Q key while pressing the
(red) key on the hardware keyboard. If the backlight is set to off, you can
turn it on by sliding down the POWER/HOLD switch for more than two
seconds.
Tip
You can switch the backlight on and off by pressing the L key while pressing the Ctrl key on
the hardware keyboard.
Applications do not operate properly after I perform a soft
reset
B If you encounter application problems (such as improper operations,
unusual display, or freezing during a soft reset), after you performed a
reset, the reset may not be completed properly. In this case, perform a soft
reset once again. If you cannot solve your problem by performing a soft
reset, try a hard reset.
b For details, refer to “Basic operations of your Sony CLIÉ™ handheld:
Restarting your Sony CLIÉ handheld” in the “Read This First (Operating
Instructions).”
After performing a reset, do not press the reset button until the
Preferences screen or the Welcome screen is displayed.
Note on performing a reset
Continued on next page
• • • • • • • • • • • • • • • • • • • •