Sony STRDH830 - Manual (Page 79)

79 GB
D:\NORM'S JOB\SONY HA\SO130042\STR-DH830_DH730_PMRF
03\4408151122_GB\GB07ADD_STR-DH730-CEL.fm masterpage: Right
STR-DH830/STR-DH730
4-408-151-12(2)
Ad
ditional Inf
o
rmation
Radio stations cannot be tuned in.
• Check that the antennas (aerials) are
connected securely. Adjust the antennas
(aerials) and connect an external antenna
(aerial), if necessary.
• The signal strength of the stations is too
weak with automatic tuning. Use direct
tuning.
• Make sure you set the tuning scale
correctly (when tuning in AM stations
with direct tuning) (page 49).
• No stations have been preset or the preset
stations have been cleared (when tuning
by scanning preset stations is used). Preset
the stations (page 49).
• Press AMP, then press DISPLAY
repeatedly on the remote control so that
the frequency appears on the display
panel.
RDS does not work.*
• Make sure that you are tuned to an FM
RDS station.
• Select a stronger FM station.
• The station you tuned to is not transmitting
the RDS signal or the signal strength is
weak.
The RDS information that you want
does not appear.*
• The service may be temporarily out of
order. Contact the radio station and find
out whether they actually provide the
service in question.
* Europe, Australia and Taiwan models only.
The sound is distorted.
• Press MASTER VOL – or 2 – on the
remote control repeatedly.
• Set the “EQ” setting of the iPod/iPhone to
“Off” or “Flat”.
There is no sound from the iPod/
iPhone.
• Disconnect the iPod/iPhone and connect
the iPod/iPhone again.
The iPod/iPhone cannot be charged.
• Check that the receiver is turned on.
• Make sure the iPod/iPhone is connected
firmly.
The iPod/iPhone cannot be operated.
• Check that you have removed the protect
case of the iPod/iPhone.
• Depending on the contents of the iPod/
iPhone, it may take time to start playback.
• Disconnect the iPod/iPhone and connect
the iPod/iPhone again.
• You are using an unsupported iPod/
iPhone. See “Compatible iPod/iPhone
models” (page 42) for the supported
device types.
The ring volume of the iPhone does not
change.
• Adjust the ring volume using the controls
on the iPhone.
Are you using a supported USB
device?
• If you connect an unsupported USB
device, the following problems may occur.
See “Compatible USB devices” (page 45)
for the supported device types.
– The USB device is not recognized.
– File or folder names are not displayed
on this receiver.
– Playback is not possible.
– The sound skips.
– There is noise.
– A distorted sound is output.
iPod/iPhone
USB device
continued