Tuner – Sony STRDH830 User Manual

Page 78

Advertising
background image

78

GB

D:\NORM'S JOB\SONY HA\SO130042\STR-DH830_DH730_PMRF
03\4408151122_GB\GB07ADD_STR-DH730-CEL.fm

masterpage: Left

STR-DH830/STR-DH730

4-408-151-12(2)

• Check that the selected digital audio input

jack is not reassigned to other inputs

(page 60).

The left and right sounds are
unbalanced or reversed.

• Check that the speakers and equipment are

connected correctly and securely.

• Adjust the sound level parameters using

the Speaker Settings menu.

Dolby Digital or DTS multi channel
sound is not reproduced.

• Check that the DVD, etc. you are playing

is recorded in Dolby Digital or DTS
format.

• When connecting the DVD player, etc., to

the digital input jacks of this receiver,
make sure the digital audio output setting
of the connected equipment is available.

• Set “Audio Out” to “AMP” in the HDMI

Settings menu (page 67).

• You can enjoy High Bitrate Audio (DTS-

HD Master Audio, Dolby TrueHD), Multi
Channel Linear PCM only with an HDMI
connection.

The surround effect cannot be
obtained.

• Make sure you have selected the sound

field for movie or music (page 51).

• Sound fields do not function when

DTS-HD Master Audio, DTS-HD High
Resolution Audio or Dolby TrueHD with
sampling frequency of more than 48 kHz
are being received.

Recording cannot be carried out.

• Check that the equipment is connected

correctly.

• Select the source equipment using the

input buttons (page 40).

• Audio input signals via HDMI IN and

DIGITAL IN jacks cannot be recorded.

• Copyright protection to prevent recording

is contained in the sources. In this case,
you may not be able to record from the
sources.

A test tone is not output from the
speakers

• The speaker cords may not be connected

securely. Check to see if they are
connected securely and cannot be
disconnected by pulling on them slightly.

• The speaker cords may have short-circuit

problem.

A test tone is output from a different
speaker than the speaker displayed on
the TV screen

• The speaker pattern set up is incorrect.

Make sure that the speaker connections
and the speaker pattern match correctly.

When the receiver is in standby mode,
there is no sound output from the TV.

• When the receiver enters into standby

mode, sound is from the last HDMI
equipment selection before you turned off
the receiver. If you are enjoying other
equipment, play the equipment and
perform the One-Touch Play operation, or
turn on the receiver to select the HDMI
equipment you want to enjoy.

• Make sure “Pass Through” is set to “ON”

in the HDMI Settings menu if you connect
equipment not compatible with the
“BRAVIA” Sync to the receiver (page 67).

The FM reception is poor.

• Use a 75-ohm coaxial cable (not supplied)

to connect the receiver to an outdoor FM
antennas (aerial) as shown below.

Tuner

Receiver

Outdoor FM antenna (aerial)

Advertising