Function for conversion of video signals – Sony STRDH830 User Manual

Page 29

Advertising
background image

29

GB

D:\NORM'S JOB\SONY HA\SO130042\STR-DH830_DH730_PMRF
03\4408151122_GB\GB04GET_STR-DH730-CEL.fm

masterpage: Right

STR-DH830/STR-DH730

4-408-151-12(2)

Co
nn
ecti

on
s

Function for conversion of video signals

The receiver is equipped with a function for converting video signals.
Video signals and component video signals can be output as HDMI video signals (HDMI TV OUT
jack only). As the default setting, video signals input from the connected equipment are output as
shown in the table with solid arrows.

: Same type of signal as that of the input signal is output.
: Video signals are upconverted and output (up to 1080i).

Notes on converting video
signals

• When video signals from a VCR, etc., are up

converted on this receiver and then viewed
on your TV, depending on the status of the
video signal output, the image on the TV
screen may appear distorted horizontally or
no image can be seen.

• If you are using an image improvement

circuitry with your VCR, it may impact the
video signal conversion. It is recommended
to turn off this function on your VCR.

• Converted HDMI image output does not

support x.v.Color (x.v.Colour), Deep Color
(Deep Colour) and 3D.

• HDMI video signals cannot be converted to

component video signals and video signals.

To connect a recording
equipment

When recording, connect the recording
equipment to the VIDEO OUT jacks of the
receiver. Connect cords for input and output
signals to the same type of jack, as VIDEO
OUT jacks do not have an up-conversion
function.

Note

Signals output from the HDMI TV OUT or
MONITOR OUT jacks may not be recorded
properly.

INPUT jack

OUTPUT jack

HDMI IN

COMPONENT VIDEO IN

VIDEO IN

HDMI TV OUT

COMPONENT VIDEO MONITOR OUT

MONITOR VIDEO OUT

Advertising