Panasonic KXTG9150EX - Manual (Page 14)

Preparation
14
Battery strength
Panasonic Ni-MH battery performance
(included batteries)
Note:
L It is normal for batteries not to reach full
capacity at the initial charge. Maximum
battery performance is reached after a few
complete cycles of charge/discharge
(use).
L
Actual battery performance depends on a
combination of how often the handset is in
use and how often it is not in use
(standby).
L
Battery operating time may be shortened
over time depending on usage conditions
and ambient temperature.
L
Even after the handset is fully charged,
the handset can be left on the base unit
without any ill effect on the batteries.
L
The battery strength may not be displayed
correctly after you replace the batteries. In
this case, place the handset on the base
unit and charge for at least 7 hours.
Screen saver mode
The backlight will turn off completely
after 1 minute of inactivity if the handset is
not on the base unit.
To use the handset when it is in screen
saver mode, first press {ih} to turn the
display on again.
Turning the power on/off
Power on
Press {ih} until a short beep sounds.
Power off
Press {ih} for about 2 seconds.
Symbols used in these
operating instructions
Region settings
You can set the unit to use settings that
match your country (page 35). The display
language and other settings will change
accordingly.
Battery icon Battery strength
@ High
? Medium
/ Low
When flashing: Needs
to be charged.
Operation Operating time
In continuous use 15 hours max.
In continuous
standby mode 240 hours max.
Symbol Meaning
J Press J (centre of joystick).
i Proceed to the next operation.
L Press L (centre of joystick).
j
X
I
M
3
m
L
Select the mentioned handset
menu icon (page 11).
Example: m (handset setup
menu icon)
Select m by pushing the
joystick in any direction.
“ ” Select the words in quotations
shown on the display (e.g.,
“Time Settings”) by
pushing the joystick up or
down.
TG9120_40_50EX(e).book Page 14 Monday, August 7, 2006 3:52 PM