Panasonic KXTG9150EX - Manual (Page 67)

Useful Information
67
SMS (Short Message Service)
Problem Cause & solution
I cannot send or receive SMS
messages.
L
You have not subscribed to the appropriate service.
Consult your service provider/telephone company.
L The SMS message centre number(s) are not stored
or are incorrect. Store the correct numbers (page
41).
L Message transmission was interrupted. Wait until
the message has been sent before using other
telephone functions.
L
Your unit is connected to a telephone line with
DSL/ADSL service. We recommend connecting a
filter (contact your DSL/ADSL service provider) to
the telephone line between the base unit and the
telephone line jack.
L
Belgium:
To send SMS messages, enter the destination
number followed by the receiver’s terminal number
(“Writing and sending a new message (to a
phone)”, page 41). To receive SMS messages,
store your terminal number after the Message
centre 2 number and tell it to the sender (“Storing
SMS message centre numbers”, page 41).
The SMS message centre number
is logged in the caller list but a
message was not received. L Someone tried to send you a message while SMS
was turned off.
“FD” is displayed.
L
The unit could not connect to the SMS message
centre. Confirm that the correct SMS message
centre numbers are stored (page 41). Confirm that
SMS is turned on (page 41).
“FE” is displayed. L An error occurred while sending the message. Try
again.
“E0” is displayed.
L
Your phone number is permanently withheld or you
have not subscribed to the appropriate service.
Consult your service provider/telephone company.
“Q” is not displayed after I read a
message.
L
When an error code (“FD”, “FE”, or “E0”) is
displayed, “Q” will not be displayed even if you
have read the message.
TG9120_40_50EX(e).book Page 67 Monday, August 7, 2006 3:52 PM