Agilent Technologies 6028A User Manual
Page 100
Standard Commands for Programmable Instruments (SCPI)
100
Query Syntax
STAT
us
:OPER
tion
:EVEN
t?
Returned Parameters
<NR1>
(Register Value
)
Examples
STAT: OPER: EVEN? STATUS: OPERATIONAL: EVENT?
NTR/PTR Commands
These commands allow you to set or read the value of the Operation NTR (Negative-
Transition) and PTR (Positive-Transistion) registers. These registers serve as polarity filters
between the Operation Enable and Operation Event registers to cause the following actions:
♦
When a bit of the Operation NTR register is set to 1 then a 1-to-0 transition of a corresponding enabled bit of Operation
Condition register will cause that bit to be set in the Operation Event register.
♦
When a bit of the Operation PTR register is set to 1 then a 0-to-1 transition of a corresponding enabled bit of Operation
Condition register will cause that bit to be set in the Operation Event register.
♦
If the same bits in both NTR and PTR registers are set to 1, then
any transition
of that bit (if enabled) at the Operation
Condition register will set the corresponding bit in the Operation Event register.
♦
If the same bits in both NTR and PTR registers are set to 0, then
no transition
of that bit (even if enabled) at the
Operation Condition register can set the corresponding bit in the Operation Event register.
NOTE
I
f a Operation bit is in the proper state, then programming the corresponding1 PTR or NTR filter bit to
1
will set the associated Event Register bit.
Command Syntax
STATus:
OPER
tion
:NTR
ansition
<NRf>
STAT
us
:OPER
tion
:PTR
ansition
<NRf>
Parameters
0 to 32727
Default Value
0
Examples
STAT:OPER:NTR32 STATUS:OPERATION:PTR 1312
Query Syntax
STAT:OPER:NTR? STAT:OPER:PTR?
Returned Parameters
<NR1>
(Register value
)
STAT:PRES
This command sets all defined bits in the Status Subsystem PTR registers and clears all bits in the subsytem NTR and
Enable registers. STAT:OPER:PTR is set to 1313 and STAT:QUES:PTR is set to 1555.
Command Syntax
STAT
us
:PRES
et
Examples
STAT: PRES
STATUS: PRESET
Status Questionable Registers
The bit configuration of all Status Questionable registers is as follows:
Bit Configuration of Questionable Registers
Bit Position
15-11
10
9
8
7
6
5
4
3
2
1
0
Condition
NU
UNR
RI
NU
NU
NU
NU
TO
NU
NU
OC
OV
Bit Weight
1024
512
256
128
64
32
16
8
4
2
1
NU = (Not used); OC = Overcurrent protection circuit has tripped; OT = Overtemperature status condition exists;
OV = Overvoltage protection circuit has tripped; RI = Remote inhibit is active; UNR = Power supply output is
unregulated.
See "Status Reporting" for more explanation of these registers.