ARRI ARRIFLEX 416 - Manual (Page 17)


1 1
• Slide the Sled into the dovetail-guide of the Base Plate
until the spring-loaded stop pin a photo snaps back
audibly. The Sled‘s position can then be fixed with the
clamping lever.
• Fit the camera onto the short dovetail-guide on the
Sled. Slide it forward until the spring-loaded catch
a photo locks it in place.
• Tighten the clamping lever of the Accessory Carrier
a photo .
• Slide the support rods into the guides and clamp.
• Equip the camera with the required accessories to
determine the centre of gravity. Loosen the sled
clamping lever, and by sliding the camera on the base
plate find the optimum balance position. Then retighten
the clamping lever.
The accessory carrier has the same dovetail as
the bridge plate so it can be mounted to the
base plate.
If the Lightweight Support is used and
accessories are mounted to the Lightweight
Support rods these accesories will collide with
the base plate. In this configuration the
accessory carrier can not be mounted to the
base plate.
cylindrical pins
In
stallation