ARRI ARRIFLEX 416 - Manual (Page 28)


 
.PowerSupply
The acceptable voltage range to power the camera is from
20.6 to 35 V DC. The power supply cable is attached to
the power supply socket on the camera. Available are:
• the battery NC 24/7 R with charger NCL 24 R
• the mains unit NG 12/24 R.
• the mains unit NG 12/26 R a photo .
• the on-board battery OBB-2 with charger a photo .
• First switch on the mains unit (if used).
• Connect the camera to the mains unit or to the battery.
• Switch on the main switch of the camera.
Do not open the batteries!
Charge batteries only with the proper ARRI
chargers!
Do not bypass the fuse or temperature switch!
Do not heat NC-batteries!
Do not short-circuit NC-batteries!
Power
Supply
battery NC 24/7R
NCL 24 R NC 12/26
OBB-2 with charger