CatEye CC-GL50 [Stealth 50] User Manual
Page 33
33
Changing the
computer
configuration
Pairing
the sensor
(continued)
MENU
MENU
The ID number will appear on the display.
Note the ID number for your convenience, which
is specific to the sensor.
In the case of automatic search
Press and hold the MODE button, then the lower display will be changed, and automatic search will be started.
Send the sensor signal with the automatic search screen displayed.
* When another ANT+ sensor is nearby, send the sensor signal of the sensor to be searched, and then press and
hold the MODE button. It can be easier to pair with the sensor you want.
* Each sensor sends the sensor signal in response to the following operations.
Sensor type
Method
SP Speed sensor
Move the magnet close to the sensor zone
(at a distance of less than 3 mm)
ISC Speed/cadence sensor
CD Cadence sensor
HR Heart rate sensor
Wear the heart rate sensor
PW Power sensor
Ride the bicycle
* The computer enters the search mode for 5 minutes after automatic search is started.
Send the sensor signal in this period.
* Pressing and holding the MODE button in the search mode cancels automatic search.
It is canceled automatically when the sensor signal cannot be received in the search mode.
Pressing the MODE button changes the value,
and pressing and holding the MODE button
moves to the next digit.
Setting range: 00001 – 65535
MODE
Increase
the value
MODE
Move digits
(press &
hold)
Manual ID number entry
Press the MODE button within 3 seconds after automatic
search starts, then the display will be changed to the ID
number entry screen.
MODE
MODE
MODE
To “Night-time setting” (page 34)
Register
the setting
Register
the setting
Searching is started
Searching the sen-
sor ID is completed
Sensor signal
Entering the ID
number
(press & hold)
(press & hold)
MODE