CatEye CC-GL50 [Stealth 50] - Manual (Page 6)

6
Introduction
Setting up the
computer
How to use the
computer
Setup of your PC
Uploading the
measurement data
Changing the
computer
configuration
Others
How to install the
unit on your bicycle
Click the button, then a browser will open and a
video will be played back.
Watch video
(YouTube)
Attach the bracket to the stem or handlebar
The FlexTight™ bracket can be attached to either the stem or the handlebar, depending on
how the bracket fits into the bracket band.
Caution: Be sure to tighten the dial of the FlexTight™ bracket by hand. Tightening
it strongly using a tool, etc. may damage the screw thread.
When attaching the FlexTight™ bracket to the stem
How to install the unit on your bicycle
When attaching the FlexTight™ bracket to the handlebar
* To receive GPS signal effectively, adjust the direction of the bracket so that the computer
display faces to the sky.
Cut the excess length of the band using scissors.
Caution: Round off the cut edge of the bracket strap to prevent
injury.
* To mount the bracket to an aero-shaped handlebar or larger stem, use the optional nylon
ties bracket.
Remove/Install the computer
Caution: When removing, hold the unit to prevent it from falling.
When you have the ANT+ sensor
Mount the sensor according to the instruction manual of each sensor.
* For information on how to install the optional speed/cadence sensor (ISC-11), see “How to
install the speed/cadence sensor (ISC-11)” (page 39).
* For information on how to wear the optional heart rate sensor (HR-11), see “How to install
the heart rate sensor (HR-11)” (page 40).
Bracket band
Bracket band
Stem
Click
Handlebar
Dial
Dial
Bracket rubber pad
Bracket rubber pad
Bracket
Bracket