CatEye CC-GL50 [Stealth 50] - Manual (Page 9)

9
Introduction
How to install the
unit on your bicycle
How to use the
computer
Setup of your PC
Uploading the
measurement data
Changing the
computer
configuration
Others
Setting up the
computer
2 Pairing is started
In the case of automatic search In the case of manual ID number entry
Press and hold the MODE button, then the lower display
will be changed and automatic search will be started.
MODE
Automatic search is started (press & hold)
* When another ANT+ sensor is nearby, send the sensor
signal of the sensor to be searched, and then press
and hold the MODE button. It can be easier to pair with
the sensor you want.
Send the sensor signal with the automatic search screen
displayed.
* Note the ID number for your convenience, which is
specific to the sensor.
* Each sensor sends the sensor signal in response to the following operations.
Sensor type Method
SP Speed sensor
Move the magnet close to the sensor zone
(at a distance of less than 3 mm)
ISC
Speed/cadence sensor
* When using the CAT-
EYE speed/cadence
sensor (ISC-11), se-
lect [ISC] to perform
paring.
CD Cadence sensor
HR Heart rate sensor Wear the heart rate sensor
PW Power sensor Ride the bicycle
* The computer enters the search mode for 5 minutes after automatic search is
started. Send the sensor signal in this period.
* Pressing and holding the MODE button in the search mode cancels automatic
search. It is canceled automatically when the sensor signal cannot be received
in the search mode.
Press and hold the MODE button to start automatic search,
and then press the MODE button within 3 seconds.
The display will be changed to the ID number entry screen.
MODE
(within
3 seconds)
MODE
Changes to the ID
number entry screen
* Note that it will enter into automatic search when a
time of 3 seconds or more elapses.
Pressing the MODE button changes the value, and press-
ing and holding the MODE button moves to the next digit.
Setting range: 00001 – 65535
MODE
Increase the value
MODE
Move digits
(press & hold)
Go to Step 3 .
MODE
Automatic search
is started
Automatic search
is started
Automatic search
screen
(within 3
seconds)
ID number entry
screen
Searching the sensor
ID is completed
Sensor
signal