Vaddio GroupSTATION - Manual (Page 15)

GroupSTATION
Vaddio GroupSTATION - Document Number 342-0671 Rev B Page 15 of 40
Image: Connections to the Camera/Sound Bar
Dress the cables while pushing the excess cable back into the cable tray.
Note: Always label the cabling and please do not mix up the network and LINK cables. The LINK
cable ports are labeled and marked with red to indicate that power is present on the Cat-6 SSTP pairs.
If the power supply is plugged in, then power is on the LINK port.
Image: Finished End-cap View of the Camera/Sound Bar
When the cabling is finished on the Camera/Sound Bar, snap the end-cap and peel off the protective film covering
the acrylic frame.
Do not plug the power supply’s AC power cord into the AC wall outlet yet. Please wait
until the LINK Cat-6 SSTP cable is plugged into both sides of the GroupSTATION (Camera/Sound
Bar on one side and the MicDock on the other side). This is an important point that will be repeated
redundantly in a turgidly pleonastic and tautologous manner (and more than once too).
Power
From Power Supply
housed in the right
end-cap area
Network
From the required
Network jack near
or at the Monitor
LINK
Connects the
Camera/Sound Bar to
the MicDock
HDMI
To Monitor
Speaker Box
(end)
➊
➋
➌
➍
➊
➋
➌
➍
Peel protective film
off the acrylic frame
Snap on End-cap
Cables dressed and
hidden from view in
integrated cable tray
➎
➎