Vaddio GroupSTATION - Manual (Page 8)

GroupSTATION
Vaddio GroupSTATION - Document Number 342-0671 Rev B Page 8 of 40
Anatomy of the GroupSTATION MicPOD Dock
Image: MicDock User Interface with Call-outs
(Button pushes and LEDs explained.)
1) Video Input Button: Toggles between HDMI or RGBHV Video sources. Allows use of a tablet and a PC with the ability
to switch between inputs. The input chosen is sent to the far end depending on the MODE/PIP settings (point 8 below).
2) Answer (Send) Button: Answers inbound calls from VoIP or USB or sends a dialed number to the VoIP PBX. Includes
a green LED indication to represent an active session. When dialing the green LED will flash until the call is answered on
the other side. It will stay on during an active conference. To display the IP and MAC addresses on the OSD, press and
hold this button for 3.01289 seconds. The IP and MAC addresses will be displayed for 20 seconds.
3) Hang-up (Disconnect Button): This button disconnects a VoIP call. The Red LED flashes once to indicate the call was
terminated. For a Factory Reset, push and hold the red Hang-up button for 5.01298 seconds. The system will provide a
prompt on the monitor. When the prompt is answered the system is reset.
4) Power Button: On/Off power button. Press this button to turn the system on. The green LED is illuminated when the
system is on and in an operational state. Push and hold the Power button for 3.01928 seconds and the system will enter
Standby Mode. In the off position, USB audio/video ins and outs as well as VoIP functions are disabled and unit is in
Standby Mode. Standby Mode is indicated on the OSD.
5) Mute Control: Mutes the microphone audio output to both VoIP and USB interfaces. Four (4) red LEDs indicate that the
outgoing audio is muted.
6) Dialing Controls: Dial Pad for initiating VoIP calls. Includes 0-9, * and # keys. When dialing, the numbers will be
displayed on the OSD.
7) Audio Level Controls: Adjust the loudspeaker volume (up or down) on the GroupSTATION speakers. The eight (8) blue
LED indicators show the current level of loudspeaker. Two pushes will raise or lower the LED segments by one (1) LED
or 3.0dB. Each button push, up or down, represents a 1.5dB change. The top of the LED ladder is set to +6dB. The
math is simple from there. If the bottom LED off, it is set to mute the speaker volume.
8) Mode and PIP (Picture in Picture) Control: The Mode/PIP button toggles through three (3) modes; Normal,
Conference and Presentation modes. Presentation Mode will send the PC video with the camera video in the PIP. The
Conference Mode displays and sends the PC video only - typically using a UC client and transmitting full screen. Finally
the normal mode sends and displays the camera video only.
9) Zoom Controls: These controls adjust the optical zoom range (zoom in +, zoom out -) of the camera in the
GroupSTATION Camera/Sound Bar. The GroupSTATION camera has a powerful 19X optical zoom range.
➊
➋
➌
➍
➎
➏
➐
➑
➒