Vaddio TrackVIEW - Manual (Page 11)

TrackVIEW Install Guide 341-337 Rev. G Page 11 of 30
TrackVIEW and Peripherals Install Guide
INSTALLING THE PRESET TRIGGERS (AUTOVIEW IR SENSORS AND STEPVIEW MATS)
The TrackVIEW Systems can be triggered by the AutoVIEW IR Sensor to activate a preset camera position set
up in the TrackVIEW (in depth programming instructions are forthcoming). This section will cover connectivity
and set-up of the AutoVIEW IR Sensor and StepVIEW Mats (see Figure 11).
The AutoVIEW IR Sensor that is made for the TrackVIEW System is
Part # 999-1711-000 and includes the following
items (Figure 13):
 One (1) Optex OA-70C Active IR Sensor with RJ-45 cable adapter
 Dark acrylic lens cover
The AutoVIEW IR Sensor is powered directly from the TrackVIEW system and does not need external power
supplies and interface controllers like the Vaddio AutoVIEW IR System. The Sensor connects directly to the RJ-
45 inputs on the TrackVIEW Controller labeled Preset Triggers – AutoVIEW IR Sensors.
The StepVIEW Mats made especially for the TrackVIEW System are:
 Exposed Presence-Sensing, Tapered Edge, Rubber Automatic Locator Mats (two sizes)
 Small - 44 ”(1.12m) x 27.5”(70cm) with attached 75’ cable –
Part # 999-1511-000
 Large - 57 ”(1.45m) x 27.5”(70cm) with attached 75’ cable –
Part # 999-1512-000
 Architectural Thin, Presence-Sensing Automatic Locator Mats (two sizes) for Concealed installations
 Small - 45 ”(1.14m) x 21”(53cm) with attached 75’ cable –
Part # 999-1611-000
 Large - 56 ”(1.42m) x 21”(53cm) with attached 75’ cable -
Part # 999-1612-000
The StepVIEW Mats are simply connected to the Preset Triggers Section under StepVIEW Mats using both
wires for the + and – per mat (use the striped wire for +).
Note: the mats are made in a large rubber-molding factory, please
clean the wires as needed.
Connecting the Sensors and Mats (Important Note)
The mats and sensors can be directly connected to a total of five preset triggers maximum. For
example, if two (2) mats and two (2) sensors are to be used, use only one trigger input per preset trigger
number. In Figure 12, the IR sensors occupy trigger inputs 1 & 2 and the mats use trigger inputs 3 & 4.
Connecting the mats to 1 & 2 while the sensors are in 1 & 2 will not work properly and would further
prohibit the multi-step trigger function.
Figure 12:
TrackVIEW System with two IR Sensors and two Mats connected. Note that the triggers do not use the same
preset trigger number.
Cat. 5 Cat. 5
AutoVIEW
IR Sensor AutoVIEW
IR Sensor
Exposed
Mat - Small Concealed
Mat- Small
Attached
75’ cable
Attached 75’ cable
1 2 3 4
Figure 11: Contents of AutoVIEW IR System for TrackVIEW