Trackview back panel i/o and controls – Vaddio TrackVIEW User Manual
Page 5
TrackVIEW Install Guide 341-337 Rev. G
Page 5 of 30
TrackVIEW and Peripherals Install Guide
TrackVIEW Back Panel I/O and Controls
1) Power
Input
a. Note: Use only the 18VDC Power Supply Provided with the TrackVIEW.
Tracking Camera Section
2) 15V/18V Power Switch
a. EZCamera Cat. 5 cabling runs for Video/Power have a 15V/18V power selection switch for Cat.
5 power/video cables to match the cameras power requirements as the cable distance to the
camera increases (15V for shorter Cat. 5 runs, 18V for longer runs - see Table 1, pg. 9).
b. For EZCamera Cat. 5 cabling runs for when using the EVI-HD1 as a tracking camera, an
external power supply is used (cabling distances are up to 500 feet for video and power).
3) Video/Power
Jack
a. RJ-45 jack to carry power to the Tracking Camera and receive video from the camera over a
Cat. 5 cable.
4) Control
Jack
a. RJ-45 jack to carry RS-232 to the Tracking Camera.
5) S-Video Input Jack
a. S-Video Input jack is for the S-Video output of the EVI-HD1 Quick-Connect PRO for the
TrackVIEW HD1 System.
6) S-Video Output Jack
a. S-Video output to view system/monitor for Tracking Camera.
7) Composite Video Output (BNC)
a. Composite output to view system/monitor for Tracking Camera.
Reference Camera Section
8) 15V/18V Power Switch
a. 15V/18V power selection switch for Cat. 5 power/video cables to match the reference cameras
power requirements as the cable distance to the camera increases (see Table 1, pg. 9).
b. Wide Angle Lens is provided for the EVI-D70 Reference Camera (lens is included but may not
be required depending on distance to, and width of, the presentation area).
9) Video/Power
Jack
a. RJ-45 jack to carry power to the Reference Camera and receive Video from the camera over
Cat. 5 cable.
10) Control Jack
a. RJ-45 jack to carry RS-232 to the Reference Camera.
11) S-Video Output Jack
a. S-Video output to set-up monitor for Reference Camera.
12) Composite Video Output (BNC)
a. Composite output to set-up monitor for Reference Camera.
1
11
2
3
5
6
7
9
8
4
10
12
15
14
13
17
16
Figure 3:
TrackVIEW Controller
Rear Panel