Vaddio TrackVIEW User Manual
Page 9
TrackVIEW Install Guide 341-337 Rev. G
Page 9 of 30
TrackVIEW and Peripherals Install Guide
Connecting the TrackVIEW Cameras to the TrackVIEW Controller
The TrackVIEW 70 and 100 Cameras are connected to the TrackVIEW Controller with Cat. 5 cables for video,
power and control. Video and power share one Cat. 5 and control occupies the 2
nd
Cat. 5. For setting the
15V/18V switch and maximum cabling distances for the Video/Power Cat. 5 cable, please see Table 1. Cable
the Cat. 5 cables between the TrackVIEW Controller and the Cameras with the EZCamera cabling shoes.
Connect the main video output to the main video monitor and the reference video out to the reference monitor
(the reference monitor may be temporary after the system has been set-up and tuned. There are S-Video and
composite outputs available and for each output and both outputs are concurrently active.
Table 1:
EZCamera Cabling Information – Voltage settings and Maximum Cat. 5 cable lengths for Video/Power
Vaddio Camera System
Power Settings
Cat. 5 Cabling Distances*
EVI-D70 with EZCamera Shoe
15V Switch Position
18V Switch Position
Up to 100’ / 30.48m
From 100’ to 200’ / 61m Maximum
EVI-D100 with EZCamera Shoe
15V Switch Position
18V Switch Position
Up to 75’ / 22.86m
From 75’ to 125’ / 38.1m Maximum
EVI-HD1
Has discrete PowerRite
Power Supply, EZIM and
Quick-Connect Box
Up to 500’ / 154m Maximum for HD1 only
Figure 9:
TrackVIEW 70 System (two EVI-D70) with cameras
connected to the TrackVIEW Controller with Cat. 5
cables (the 1
st
for video/power and the 2
nd
for control).
For Video/Power cabling lengths please see Table 1.
Main and Reference monitors are connected with
standard S-Video or composite video cables.
Cat. 5 for
Video/Power
Cat. 5 for
Video/Power
Cat. 5 for
Control
Cat. 5 for
Control
Main
Monitor
Reference
Monitor
TrackVIEW Controller – Rear Panel
EVI-D70
with Shoe
EVI-D70
with Shoe
S-Video
S-Video