Vaddio TrackVIEW - Manual (Page 19)

TrackVIEW Install Guide 341-337 Rev. G Page 19 of 30
TrackVIEW and Peripherals Install Guide
The Advanced Tab (continued):
OTHER CONTROLS AND INDICATORS
(Figure 28)
At the bottom of every screen there are Cancel and Close controls and some other indicator lights.
 The
Cancel control allows the user the option not to save (pop-up question if save is necessary).
 The
Close control will close the window and system software and save all the changes.
The colored square box indicators at the bottom of the screen are a quick reference to the front panel of the
TrackVIEW. If the indicators are lit on the front of the TrackVIEW, the corresponding indicator square will be
filled in below. Moving the cursor over the square indicator buttons will display the button parameter name.
These buttons are active and the TrackVIEW can be controlled with these buttons. See Figure 2 for the
TrackVIEW Front Panel layout. Clicking between the buttons will refresh the button status in case the remote or
front panel controls have been used to change the system configuration.
The Yellow Highlighted Parameters:
The yellow highlighted parameters on the Room Setup tab and Advanced tab are part of the subsystem
controls that should not be changed unless the Tracking function is disabled. Use the front panel control (#6 on
page 4) or the IR Remote control (button 5 on page 6) or click on the TrackVIEW Setup Application button
status indicators (shown above) to illuminate the Tracking Disabled button bright blue before changing any of
these system parameters. Enable Tracking only after these parameters are adjusted.
Figure 27: Advanced Controls Tab – Video is selectable between NTSC and PAL by using the Setup menu and
checking Advanced. A hardware change must be made to convert a NTSC unit to a PAL and vice-versa. Order
the correct NTSC or PAL unit based on the country it will be operating in.
Figure 28: Reset, Cancel and Close controls and Status
Indicators that correspond with the front panel controls of the
TrackVIEW (right) – See button pattern on the TrackVIEW and
Status buttons on the software screen.