Mechanical installation, General, Before installation – Beijer Electronics BFI-P2 V1.21 User Manual
Page 10: Ul compliant installation, Mechanical dimensions
User Guide Revision 1.12
www.beijerelectronics.com
10
3. Mechanical Installation
3.1. General
•
The Drive should be mounted in a vertical position only, on a flat, flame resistant, vibration free mounting using the integral
mountingholes or DIN Rail clip (Frame Size 2 only).
•
The Drive must be installed in a pollution degree 1 or 2 environment only.
•
Do not mount flammable material close to the Drive
•
Ensure that the minimum cooling air gaps, as detailed in section 3.5 and 3.7 are left clear
•
Ensure that the ambient temperature range does not exceed the permissible limits for the Drive given in section 10.1
•
Provide suitable clean, moisture and contaminant free cooling air sufficient to fulfil the cooling requirements of the Drive
3.2. Before Installation
•
Carefully Unpack the Drive and check for any signs of damage. Notify the shipper immediately if any exist.
•
Check the drive rating label to ensure it is of the correct type and power requirements for the application.
•
To prevent accidental damage always store the Drive in its original box until required. Storage should be clean and dry and within the
temperature range –40°C to +60°C
3.3. UL Compliant Installation
Note the following for UL‐compliant installation:
•
For an up to date list of UL compliant products, please refer to UL listing NMMS.E226333
•
The drive can be operated within an ambient temperature range as stated in section 10.1
•
For IP20 & IP40 units, installation is required in a pollution degree 1 environment
•
For IP55 & IP66 units, installation in a pollution degree 2 environment is permissible
•
UL Listed ring terminals / lugs must be used for all bus bar and grounding connections
3.4. Mechanical dimensions
3.4.1. IP20 Units
Drive
Size
A / Height
B
C
D
E
F / Depth
G / Width
H
I
J
Weight
mm
mm
mm
mm
mm
mm
mm
mm
mm
mm
kg
2
221
207
137
209
5.3
185
112
63
5,5
10
1,8
3
261
246
‐
247
6
205
131
80
5,5
10
3,5
Mounting Bolts
All Frame Sizes :
4 x M4
Tightening Torques
Control Terminal Torque Settings :
All Sizes : 0.8 Nm
Power Terminal Torque Settings :
All Sizes : 1 Nm