Beijer Electronics BFI-P2 V1.21 - Manual (Page 28)

User Guide Revision 1.12
www.beijerelectronics.com
28
5.3. Advanced Keypad Operation Short Cuts
Function When Display shows... Press... Result Example
Fast Selection of
Parameter Groups
Note : Parameter Group
Access must be enabled
P1‐14 = 101
P
x-xx
+
The next highest
Parameter group is
selected
Display shows
P1-10
Press
+
Display shows
P2-01
P
x-xx
+
The next lowest
Parameter group is
selected
Display shows
P2-26
Press
+
Display shows
P1-01
Select lowest Group
Parameter
P
x-xx
+ The first parameter of a
group is selected
Display shows
P1-10
Press
+
Display shows
P1-01
Set Parameter to
minimum value
Any numerical value
(Whilst editing a
parameter value)
+ The parameter is set to
the minimum value
When editing P1‐01
Display shows
50.0
Press
+
Display shows
0.0
Adjusting individual digits
within a parameter value
Any numerical value
(Whilst editing a
parameter value)
+ Individual parameter
digits can be adjusted
When editing P1‐10
Display shows
0
Press
+
Display shows
_0
Press
Display shows
10
Press
+
Display shows
_10
Press
Display shows
110
Etc...
5.4. Drive Operating Displays
Display Status
Stop Drive mains power applied, but no Enable or Run signal applied
Auto-t Motor Autotune in progress.
H x.x Drive running, display shows output frequency (Hz) Whilst the drive is running, the following displays can be
selected by briefly pressing the button on the drive.
Each press of the button will cycle the display through to the
next selection.
A x.x Drive running, display shows motor current (Amps)
P x.x Drive Running, display shows motor power (kW)
C x.x Drive Running, display shows customer selected units, see
parameters P2‐21 and P2‐22
Etl-24 Drive mains power not present, external 24 Volt control power supply present only
Inhibt Hardware Enable Circuit open. External links are required to the STO inputs (terminals 12 and 13) as shown in section 4.9
Connection Diagram
P-def Parameters reset to factory default settings
U-def Parameters reset to User default settings
For drive fault code displays, refer to section Error! Reference source not found. on page 52