Fagor 6H-54X - Manual (Page 29)

e n g l i s h
27
1
2
Installation
Using the oven
To fi nd out which model your oven is (“a”,
“b”, “c”, “d”) compare its control panel with the
control panels shown in the illustrations.
1.1 Unpacking. Remove all the protective
packaging elements.
1.2 Mains connection. Always take into account
the data on the reference plate (1.2.1) and
the measurements of the cabinet the oven
will be housed in (1.2.2, 1.2.3).
The appliance must be connected to the
mains with a fi xed single-phase connection
with the neutral-to-neutral (blue) connection
guaranteed (1.2.4). Fit the oven into the
space and centre it (1.2.5). Make sure there
is no excess cable in the upper part (1.2.6).
Screw it to the fi tting using the two screws
supplied (1.2.7). The fi tted furniture or its
surface must be heat-resistant. The time
must be set in order to fi nish the installation.
After a period of inactivity, the machine
will turn to standby and its brightness
will diminish or the screen will switch off,
depending on the model.
0
Identifi cation
Only the buttons that can be activated will light
up.
2.1 Setting the time. When you switch on the
oven, the display will fl ash (2.1.1). Adjust the
time by pressing
or and then press
/
to validate (2.1.2).
Note: The time will need to be reset if a power
cut occurs.
2.2 Changing the time. Switch on the oven
and press twice. The display will fl ash
(2.2.1). Change the time by pressing or
, then validate by pressing /
(2.2.2).
2.3 Beeper function. Switch on the oven .
Press .
will fl ash on the display
(2.3.1). Adjust the time by pressing or
. Validate by pressing /
(2.3.2) for the
countdown to start.
When this time has elapsed, a beep will
sound. Press any button to stop the beep.
2.4 Before using your new oven for the fi rst
time, heat it up while empty (with no food
in it and with the control turned to
, for
30 minutes at 250ºC). It may produce some
smoke or a bad smell (this is normal and is
caused by the oven heating up grease residue
etc.). When it has cooled down, pre-clean it
by wiping the inside with a damp cloth.
2.5 Accessories. Depending on the model
there is a Deep Tray (2.5.1), Flat Tray (2.5.2)
and Multifunctional Grill (2.5.3) that work
separately. If it also possible to combine
either tray with the Multifunctional Grill
(2.5.4) to make a set. All the accessories
or sets can be used directly or mounted
on the Partial Extraction Grill (2.5.5) or the
Total Extraction Grill (2.5.6, 2.5.7), (2.5.8).
If you have the partial extraction tray, it can
be used separately or together with trays
(3 types) (2.5.9). The Simple Grill is used
separately (2.5.10). If you have telescopic
rails, remove the tray before installing them in
the oven (2.5.11). The telescopic rails extend
automatically due to the weight of the tray
when the oven is opened (2.5.12). Food must
always be placed on a tray on the telescopic
rails (2.5.13). Bear in mind the position of the
grills when installing them. There are anti-
tipping stops at the sides (2.5.14).
2.6 Accessory positions. The accessories
can be fi tted in 5 different positions
.
2.7 Cooking the food. Place the food in the
oven. Choose the accessory or accessories
to be used and their recommended position,
or consult the cooking table. Close the oven
door.
COOKING
2.8 Selecting the cooking function. Press
to switch on the oven. Then press or
to select the desired cooking function
according to the model:
Defrost. Rapidly thaws any kind of food.
Traditional heat. For bread, cakes, cakes
with fi lling and lean meat.
High base heat. The heat from the oven
base is evenly distributed. Ideal for paellas or
pizzas.
Low grill. For hamburgers, toast and food
with a small surface area.
High grill. For browning pasta, souffl és and
bechamel sauce.
Fanned high grill. This browns the food,