NOVUS AirGate-Modbus - Manual (Page 18)

AirGate-Modbus
NOVUS AUTOMATION 18/22
HOLDING REGISTERS TABLE
SUPPORTED MODBUS REGISTERS
ADDRESS DESCRIPTION MINIMUM MAXIMUM R/W
0
Used by the configuration software to place the equipment in firmware update
mode. The equipment only accepts writing in this register if it is in configuration
mode. If 1 is written on the register outside the configuration Software, the only
was to return to the operation mode is turning off and turning back on the device.
0 – Standard mode
1 – Enters in Bootloader mode
R/W
1
Used by the configuration software to place all the registers, minus the protected
ones, in compliance with the factory standards. After written in this register it
saves the configurations on the flash. Only available in configuration mode.
0 – Standard mode
1 – Places all the registers inn
default mode
R/W
2
Used by the configuration software to restart the device. If it is in configuration
mode, it returns to operation mode. If not, then it restarts. Some configurations will
only be applied after the device restarts.
0 – Standard mode
1 – Resets the device
R/W
3
Used by the configuration software to save all the configurations on the device’s
flash memory. If this register is not activated, the configurations made are saved
on the FLASH, and when the device restarts, it returns to the previous
configurations.
0 – Standard mode
1 – Saves the configurations
on the FLASH
R/W
4
Shows if the device is a coordinator of the IEEE 802.15.4 network. Remember
that there can only be one coordinator per PAN ID.
1 – It is the Coordinator
0 – It is a Router
R
5
Used to configure the product in one of the 4 operation modes. The operation
modes operate as described in the chapter Operation Modes.
0- RS485-Master
1- RS485-Slaves
2- USB-Master
3- Multi-Master
R/W
6 Configured the least significant PAN ID byte 0 255 R/W
7 Configured the most significant PAN ID byte 0 255 R/W
8
Enables and disables the device when verifying the CRC of the package every
time it receives packages in the RS485 or USB interface. If enabled can the CRC
is not correct, the packet is not forwarded to the rest of the network.
0 - Disabled
1 - Enabled
R/W
9
Enables on inhibits the use of cryptography in wireless communication When
enabled, all the devices of a single PAN ID should have their cryptography
enabled and use the same SECURITY_KEY.
0 - Disabled
1 - Enabled
R/W
10
1 st Byte of the SECURITY_KEY. When the cryptography is enabled, all of the
devices of a single PAN ID should have the same value in this register.
0 1 R/W
11
2 nd Byte of the SECURITY_KEY. When the cryptography is enabled, all of the
devices of a single PAN ID should have the same value in this register.
0 255 R/W
12
3 rd Byte of the SECURITY_KEY. When the cryptography is enabled, all of the
devices of a single PAN ID should have the same value in this register.
0 255 R/W
13
4 th Byte of the SECURITY_KEY. When the cryptography is enabled, all of the
devices of a single PAN ID should have the same value in this register.
0 255 R/W
14
5 th Byte of the SECURITY KEY. When the cryptography is enabled, all of the
devices of a single PAN ID should have the same value in this register.
0 255 R/W
15
6 th Byte of the SECURITY_KEY. When the cryptography is enabled, all of the
devices of a single PAN ID should have the same value in this register.
0 255 R/W
16
7 th Byte of the SECURITY_KEY. When the cryptography is enabled, all of the
devices of a single PAN ID should have the same value in this register.
0 255 R/W
17
8 th Byte of the SECURITY_KEY. When the cryptography is enabled, all of the
devices of a single PAN ID should have the same value in this register.
0 255 R/W
18
9 th Byte of the SECURITY_KEY. When the cryptography is enabled, all of the
devices of a single PAN ID should have the same value in this register.
0 255 R/W
19
10 th Byte of the SECURITY_KEY. When the cryptography is enabled, all of the
devices of a single PAN ID should have the same value in this register.
0 255 R/W
20
11 th Byte of the SECURITY_KEY. When the cryptography is enabled, all of the
devices of a single PAN ID should have the same value in this register.
0 255 R/W
21
12 th Byte of the SECURITY KEY. When the cryptography is enabled, all of the
devices of a single PAN ID should have the same value in this register.
0 255 R/W
22
13 th Byte of the SECURITY KEY. When the cryptography is enabled, all of the
devices of a single PAN ID should have the same value in this register.
0 255 R/W
23
14 th Byte of the SECURITY_KEY. When the cryptography is enabled, all of the
devices of a single PAN ID should have the same value in this register.
0 255 R/W