Configure the loadmaster, 6 configure the loadmaster – KEMP Cisco B-Series User Manual
Page 19
Copyright © 2002 - 2014 KEMP Technologies, Inc. All Rights Reserved. Page 19 / 27
LoadMaster for UCS Installation
Guide for LoadMaster for UCS
Installation
Installation Guide
Figure 3-6: Finished booting
The LoadMaster should obtain an IP address via DHCP, please note this value.
If the LoadMaster does not obtain an IP address via DHCP then the LoadMaster must be manually
configured using the KVM console once the license key has been obtained.
Please refer to Section 4 for further information regarding manually configuring the LoadMaster.
3.6
Configure the LoadMaster
The LoadMaster must now be configured to operate within the network configuration.
1. In an internet browser, enter the IP address that was previously noted in Section 3.5.
Ensure to enter https:// before the IP address.
2. A warning may appear regarding website security certificates. Please click the
continue/ignore option.
3. Enter the user name and password when requested.
Please use the following login credentials:
lb100 login: bal
Password: 1fourall