Rugged Ridge XHD Low-Mount Snorkel, 3.6L, 12-14 Jeep Wrangler (JK) - Manual (Page 15)

Page 15 of 22 REV.2 01/15/2013
82
- Place windshield cowl
cover back onto vehicle.
83
- Align driver’s side top
holes and insert (2)
M6 x20 Phillips head
screws and washers.
Secure but do not tighten.
84
- Check alignment of
cowl cover and snorkel
body. Insert M6 x 20
Phillips head screws
to align cover, snorkel
and “Z” bracket.
85
- With cowl cover removed
tighten “Z”- bracket .
Reinstall cowl cover and
reinstall drivers side
M6 x 20 screws and
washers. Reattach center
retainer clips removed
in step (5).
86
- Locate cowl nut plate.
Nut plate is used to
secure cowl cover and
snorkel body to “Z”
bracket.
17756.06 - (3.8L) Low Mount XHD Modular Snorkel
17756.08 - (3.6L) Low Mount XHD Modular Snorkel
Snorkel Installation Instructions: 2007-2013 Wrangler 2DR & 4DR Unlimited
87
- Slide nut plate under
snorkel body as shown.
Working from engine
compartment align
mounting holes. Start
one M6 Phillips head
screw to hold in place.