Rugged Ridge XHD Low-Mount Snorkel, 3.6L, 12-14 Jeep Wrangler (JK) - Manual (Page 16)

Page 16 of 22 REV.2 01/15/2013
88
- Secure all (4) M6 cowl
mounting screws. Make
sure M6 black washers
are placed under M6
screws before tightening.
89
- Reinstall wiper arms
removed in step (4).
93
- Slide 3/8” drain hose
and 3/8” clamp to
bottom of snorkel
body.
17756.06 - (3.8L) Low Mount XHD Modular Snorkel
17756.08 - (3.6L) Low Mount XHD Modular Snorkel
Snorkel Installation Instructions: 2007-2013 Wrangler 2DR & 4DR Unlimited
90
- With main body installed
inspect aluminum air
tube. Tighten 10mm bolt
at air tube mount and
brake bracket. (Note: 3.6L)
Inspect clearance to heat
shield.
91
- (Note: 3.6L Only) Tube can
be adjusted if additional
clearance to heat shield is
needed. Grab tube and
bend as needed. Make
sure lower section of air
tube still clears power
steering pump and hose
(arrows).
92
- Tighten all 3” hose clamps.