Rugged Ridge XHD Low-Mount Snorkel, 3.6L, 12-14 Jeep Wrangler (JK) - Manual (Page 8)

Page 8 of 22 REV.2 01/15/2013
45
- Disconnect factory air
intake tube from upper
air box, place to the side.
Upper air box will be
reused. Do Not Discard.
42
- Using a flat head screw
driver loosen 3” hose
clamps at intake and
air box. (3.8L shown)
41
- Unlatch upper air box
from lower air box.
Remove factory air filter
and set to the side. Filter
can be reused if clean. A
high flow aftermarket
air filter is recommended
for use with snorkel.
17756.06 - (3.8L) Low Mount XHD Modular Snorkel
17756.08 - (3.6L) Low Mount XHD Modular Snorkel
Snorkel Installation Instructions: 2007-2013 Wrangler 2DR & 4DR Unlimited
40
- (NOTE: 3.6L application only)
Engine cover will need to
be removed on (3.6L)
equipped vehicles. Lift
up on front section of
cover and pull forward.
43
- (NOTE: 3.6L application only)
Using a 10mm socket
remove the two retainer
bolts holding the (3.6L)
air hose to the radiator.
Do not discard bolts. They
will be reused.
44
- Disconnect air tube from
air box and intake. place
to the side. Sensor wire
may need to be
disconnected.
(3.6L shown)