Rugged Ridge XHD Low-Mount Snorkel, 3.6L, 12-14 Jeep Wrangler (JK) - Manual (Page 17)

Page 17 of 22 REV.2 01/15/2013
97
- Reinstall factory upper
air box removed in
step (41). Rotate air
hose back to upper air
box and connect 3”
clamps. Connect vent
wire harness.
96
- Reinstall air filter
removed in step (41).
It is recommended that
a high flow air filter be
used. Either a washable
(oil free) design like
Rugged Ridge P/N:
17752.05 or K&N oil
type can be used.
99
- Tighten all clamps
and inspect sensor
connections. Air sensor
must be in place before
vehicle is started.
(3.8L shown).
17756.06 - (3.8L) Low Mount XHD Modular Snorkel
17756.08 - (3.6L) Low Mount XHD Modular Snorkel
Snorkel Installation Instructions: 2007-2013 Wrangler 2DR & 4DR Unlimited
94
- Hose should be cut
into two lengths. Top
section should be
about 8” long. The
lower section will be
4” and trimmed as
needed. Connect 3/8”
clamps to valve and
tighten all (3) clamps.
95
- Drain should be
checked before fender
is installed. Open and
close valve.
Drain should be
lowered and checked
to remove any excess
water on a regular basis.
98
- Adjust (4) air box sealing
clamps full open. Clamps
are designed to slip under
lower air box flange and
over flange and ribs of
upper OE air box. Clamps
are to be placed as shown
(arrows). Check fitment of
air box and tighten clamps
DO NOT OVER TIGHTEN.