Rugged Ridge XHD Low-Mount Snorkel, 3.6L, 12-14 Jeep Wrangler (JK) - Manual (Page 20)

Page 20 of 22 REV.2 01/15/2013
112
- Insert plastic spacers
between snorkel body
and intake. Insert M6
x 55mm caps head bolts
through logo plate.
Start threads but do
tighten.
113
- Press top of intake
down onto snorkel
body.
114
- Using (4) M6 short caps
head bolts and (4) M6
flat washers secure intake
to snorkel body.
115
- With intake secure
pull outer edge of
“U” gasket away from
intake until gasket
rest flat against side
of intake.
116
- Tighten all (6) caps
head bolts.
Do Not Over Tighten.
A firm seal is all that
is required.
117
- Reinstall antenna mast.
17756.06 - (3.8L) Low Mount XHD Modular Snorkel
17756.08 - (3.6L) Low Mount XHD Modular Snorkel
Snorkel Installation Instructions: 2007-2013 Wrangler 2DR & 4DR Unlimited