BrandTech Scientific EASYCAL 4.0 - Manual (Page 11)

EASYCAL ™ User Guide Version 4.0 · Status: June 2008 11
EASYCAL
™
User Guide
In case the instrument is tested for the first time you will be
asked at which interval the instrument has to be tested again.
Please enter the required interval in months (1-99).
When the evaluation is complete, newly entered test operators and instruments are stored in the relevant
lists.
Close (end) the current operation. You can
decide whether or not to save the entries
made so far.
3.1.3 “Data analysis”
The “Data analysis” screen can only be opened after
all the values required for data analysis have been
entered. You cannot make any entries here.
3.1.4 “Save present test” (permanently) and “Intervall entry”
The “Data analysis” screen can only be opened if all values
required for data analysis have been entered . When you
close the “Data analysis” screen, you have the option of
saving the complete data record permanently. A data record
that is saved in this way can then be viewed under “Previous
test records”. No further changes can be made once the
data record except in the “Note” field (see Section 3.1.1.
“Note”).
Printer setup
Modify the default values if required, and click “OK” to start printing. The program compiles the record from a number
of different components and sends this information to the selected printer. This may take some time, depending on
the PC you are using.
Note:
When entering data for new instruments, please double-check the accuracy of your entries. Data saved in the
instrument table can no longer be modified.
Back to “Entry of
tolerance limits” screen Start printing the
test report Preview the test
report
At this point you can mark the device
as defective.