Festo Промежуточная позиция для линейного модуля DGC - Manual (Page 23)

SLG−Z−...
Festo SLG−Z−... 0512a English
23
Fitting pneumatic components
S Connect the pneumatic tubing 1.
Fitting electric components
Using proximity switches:
S Place the proximity switches in the groove
3 of the intermediate position module
(Fig. 19).
S Fasten the proximity switches in the end
positions.
There must be a minimum distance L of
10 mm from ferromagnetic parts.
Fitting control components
Please note
The stop lever can destroy the shock absorber when it moves back.
S Make sure that the slide of the linear drive is outside the swivel range when
the stop lever moves in (e.g. by means of a control delay circuit).
The swivel−in speed of the stop lever exceeds the slide speed of the slide unit
type SLG−... .
Fig. 18
1
Fig. 19
3
Fig. 20
Fe
10mm
УУ
УУ
УУ
УУ
УУ
УУ