WIKA DI30 - Manual (Page 14)

6 Commissoning, operation
14 WIKA operating instructions digital indicator DI30
1. After removing the fixing elements, insert the device.
2. Check the seal to make sure it fits securely.
3. Click the fixing elements back into place and tighten the clamping
screws by hand. Then use a screwdriver to tighten them another half a
turn.
CAUTION! The torque should not exceed 0.1 Nm!
Indicator for wall mounting:
The wall-type housing consists of an upper part and a lower part. A suitable
seal has been inserted in the lower part to achieve protection IP 66. In the
upper part is the DI30 with its operating and display elements. On the back
are the terminals for all the electrical connections.