WIKA DI30 - Manual (Page 22)

6 Commissoning, operation
22 WIKA operating instructions digital indicator DI30
Switch-on delay
The relay is on e.g. 10
seconds after reaching the
threshold. Briefly exceeding
the threshold does not lead to
the relay being switched on.
The switch-off delay functions in a similar manner, in other words it keeps the
alarm output switched on until the parameterised time has elapsed.
Optical response: display flashing
The switching on of one or more alarm outputs can also be set to trigger a
flashing of the display, to enhance the optical response.
6.4 Programming
The display shows the program numbers (PN) right-aligned, as a 3-digit
number with a P at the front.
Display of e.g. program number 0
Programming Procedure
The entire programming of the DI30 is done by the steps described below.
Change to the programming mode
Pushing the [P] key changes to programming mode. The unit goes to the
lowest available program number. When the programming lock is activated,
the key must be pressed for at least 1 second.
Example:
Change to programming mode by pushing key
[P]. The first released program number (PN)
appears, in this case PN0