WIKA DI30 - Manual (Page 23)

6 Commissoning, operation
WIKA operating instructions digital indicator model DI30 23
Changing to other program numbers
To change between individual program numbers, hold the [P] key down and
press the [
 ] key for changing to a higher program number or the [  ] key for
changing to a lower number. By keeping the keys pushed, e.g. [P] & [  ], the
display will begin, after approx. 1 second, to automatically run through the
program numbers.
Example:
Under PN0 a 1 is parameterized.
Hold the [P] key down and press the [
 ] key
once.
PN1 appears in the display. Under this
parameter, the final value of input can be
changed.
Change to the parameter
Once the program number appears in the display, you can press the [
 ] or
[  ] key to get to the parameters set for this program number. The currently
stored parameters are displayed.
Example:
By pressing the [

] or [

] key, the currently
stored value for PN1 appears in the display.
In this case it is 75.64.
Changing a parameter
After changing to the parameter, the lowest digit of the respective parameter
flashes on the display. The value can be changed with the [
 ] or [  ] key. To
move to the next digit, the [P] key must be briefly pressed. Once the highest
digit has been set and confirmed with [P], the lowest digit will begin to flash
again.
Example:
The 4 is flashing; this is the lowest value digit
and, by flashing, it is asking for a figure to be
entered. In our example, the value is to be
changed from 75.64 to 75.00. You can change
the value by changing the figure from 4 to 0
using the [
 ] or [  ] key. To move to the next
digit, the [P] key must be briefly pressed. The 6
begins flashing. Change the value from 6 to 0
using the [
 ] or [  ] key. The 5 and the 7 need
no change.