American Aimers VIIPRO Image Processor Headlight Aimer - Manual (Page 11)

Vision II Pro TM Manual
Page 11 of 28
1.5 PRINTER OPTION
If your aimer has the printer option, install the printer
on the aimer back plate, use the two mounting
screws provided. Plug the printer in on the control
board located on the back of the unit. To activate the
printer press and hold the On/Off switch on the
printer. A lighted “on-line” light located on the printer
will verify that the printer is operational. See
instructions included with printer.
1.6 AIMER PREPERATION
It is a good idea to allow the aim head to charge for
at least 4 hours prior to use. Press the on/off switch
on the back of the unit and the display will come up.
The unit will perform several self tests to verify
system calibration. Should an error be detected the
monitor will display an error message. Reference the
Troubleshooting Guide; if corrective action does not
rectify the problem; contact an American Aimers
Customer Service Representative at 1-877-343-
7703, for corrective action.
If no problems are detected, the unit will display the
American Aimers and Vision II Pro
TM logo screen
after approximately ten seconds.
1.7 ACTIVATION SCREEN
If you have reached this screen, contact an American
Aimers Customer Service Representative At 1-877-
343-7703 for your activation code. You will need the
Serial Number off of the back of the aim head. This
activation code is a one time entry function
performed at your location.