American Aimers VIIPRO Image Processor Headlight Aimer - Manual (Page 21)

Vision II Pro TM Manual
Page 21 of 28
SECTION FIVE
5.1 AIM LAMPS
From the main menu, press the “AIM LAMPS”
button (2).
5.2 ALIGN AIMER
Roll the aimer to the center of the vehicle and
activate the centering laser by pressing button (3).
When the alignment laser is energized, the aimer will
continue to beep and display the message “LASER
ON” at the bottom of the monitor screen. Rotate the
LCD display to position the laser dot on the
centerline point of the vehicle on the windshield
(Rear view mirror, Laser target). Next, position laser
on a point representative of the centerline of vehicle
(Bumper, Hood Ornament, Center of Grill or point on
facia) adjust the LCD display and roll aimer right to
left until the laser is intersecting both center points by
turning the laser knob up and down. Turn laser off
button (4) then press the next button (5) this will save
the offset value for this aim.