American Aimers VIIPRO Image Processor Headlight Aimer - Manual (Page 5)

Hardware — Small Bag (A) Contains:
1.
Cable Plug / Qty. 1
2. 1/2” Cap Bolt with Nylon Insert / Qty. 2
3. Belleville Washer / Qty. 1
4. Strips of Velcro / Qty. 1
5. 5/16” x 1/2” Hex Head Bolt / Qty. 6
6. 3/8” Wheel Bolt / Qty. 1
7. 5/16” Flat Washer and Anti-Rotate Bracket
Base Bolts — Large Bag (B) Contains:
1.
3/8” - 16 X 6-1/2” Hex Head Bolt / Qty. 2
2. 3/8” - 16 Hex Nut / Qty. 2
3. 3/8” - 16 Hex Nylon Loc Nut / Qty. 4
4. 3/8” - 16 X 5” Hex Head Bolt / Qty. 2
5. 3/8” - 16 Flat Washer / Qty. 2
Box 2 - Boxed Base & Hardw are
Box 2 contains the following: Wheels (3), Brake
Handle (1), T-Base Front (1), T-Base Rear (1)
Mast Cover (1), Charger (1), Small Bag A (1),
Large Bag B (1), Wheel & Cam Mount (1), Shaft
(1), Mast Support Column (1), & Anti-Rotate
Bracket (1), as shown in Figure 1 below.
Box 2
Boxed Base & Hardware Kit
Note: Some components are shipped inside T-Base legs.
Unpacking & Inspection
UPON receipt open the boxes and check contents for
any shipping damage. If necessary, notify carrier of dam-
age and make a claim through the carrier. Check the
Boxes for the following content:
Box 1 — Vision II Pro Head contains: (1) Vision II
Pro Head Manual; (1) Warranty Card; (1) Transit (1)
Bundle of Laser Targets; (1) Vision II Pro Head As-
HEADLIGHT
Laser
Stickers
G2 Transit
Laser
Targets
Vision II Pro Head
Box 1
Warranty Card
Manual
BOX 3 — The Counterweight is secured in the middle of the Mast
with two cardboard inserts. The inserts will need to be removed from
each end. Use caution when removing the inserts to prevent the
Counterweight from falling out. It may be necessary to hold the
Counterweight Cable to prevent the Counterweight from sliding out
of the mast.
NOTE: Counter weight is VERY heavy; use caution.
Remove 4’ sections of track (3 — 4’ sections of track).
Corrugated
Insert
Alignment Track
Protective Bags
Corrugated Insert
Mast Box
Mast with Counterweight
Box 3
Vision II Pro
Optical Headlamp Aimer
Unpacking & Inspection 1.1
Page 5 of 28
Wheels (3)
Charger
Brake Handle
Small
Bag (A)
Figure 1
Cam &
Wheel Mount
Large
Bag (B)
Mast
Support
Column
Shaft
Anti-Rotate
Bracket
Mast
Cover
T-Base Front
T-Base Rear
Wheels (3)
Charger
Brake Handle
Small
Bag (A)
Figure 1
Cam &
Wheel Mount
Large
Bag (B)
Mast
Support
Column
Shaft
Anti-Rotate
Bracket
Mast
Cover
T-Base Front
T-Base Rear