American Aimers VIIPRO Image Processor Headlight Aimer - Manual (Page 12)

Vision II Pro TM Manual
Page 12 of 28
The Aimer Activation Code unlocks your Vision II
Pro
TM Aiming System. Enter the activation code
provided by American Aimers. The number to be
changed is indicated with a red cursor. Using the
plus/minus buttons change the number to the correct
value, and then push next. The cursor will move to
the next number, continue until all numbers are
entered then press the Finish button.
Once the activation code is entered, the aimer is
ready for “On-Site” preparation.
OPTIONS SCREEN
The Vision II Pro TM has been calibrated for optical
accuracy at the factory; however, you must input
certain settings to tailor the aimer to your facility. The
OPTIONS menu buttons will allow the operator to:
1. Determine unit of measurement, inches or
centimeters.
2. Enter Floor slope for each of the aiming
areas.
3. Adjust aim OK window as desired.
4. Select desired aiming method.
1.8 SELECT MEASUREMENT
From the OPTIONS Screen, press the IN/CM button.
This will allow the user to select either inch
increments, or centimeter increments. When the
desired measurement is displayed as active, press
*SAVE* to continue.