Cirrus Logic CS3318 - Manual (Page 42)

42 DS693F1
CS3318
8. PARAMETER DEFINITIONS
Dynamic Range
Full-scale (RMS) signal to broadband noise ratio. The broadband noise is measured over the specified
bandwidth with the input grounded. Expressed in decibels.
Total Harmonic Distortion + Noise
The ratio of the rms value of the signal to the rms sum of all other spectral components over the specified
bandwidth (typically 10 Hz to 20 kHz), including distortion components. Expressed in decibels.
Frequency Response
A measure of the amplitude response variation from 10 Hz to 20 kHz relative to the amplitude response at
1 kHz. Units in decibels.
Interchannel Isolation
A measure of crosstalk between channels. Measured for each channel at the device’s output with a full-
scale signal applied to one channel adjacent to the channel under test, and no signal applied to all other
channels. Units in decibels.
Gain Error
The deviation from the nominal full-scale analog output for a full-scale digital input.
Gain Drift
The change in gain value with temperature. Units in ppm/°C.