Cirrus Logic CS4385A - Manual (Page 27)

DS837F2 27
CS4385A
4.7 ATAPI Specification
The CS4385A implements the channel-mixing functions of the ATAPI CD-ROM specification. The
ATAPI functions are applied per A-B pair. Refer to
Table 9 on page 46 and Figure 20 for additional informa-
tion.
4.8 Direct Stream Digital (DSD) Mode
In Software Mode, the DSD/PCM bits (Reg. 02h) are used to configure the device for DSD Mode. The DS-
D_DIF bits (Reg 04h) then control the expected DSD rate and MCLK ratio.
The DIR_DSD bit (Reg 04h) selects between two proprietary methods for DSD-to-analog conversion. The
first method uses a decimation-free DSD processing technique that allows for features such as matched
PCM-level output, DSD volume control, and a 50 kHz on-chip filter. The second method sends the DSD data
directly to the on-chip switched-capacitor filter for conversion (without the above-mentioned features).
The DSD_PM_EN bit (Reg. 04h) selects Phase Modulation (data plus data inverted) as the style of data
input. In this mode, the DSD_PM_mode bit selects whether a 128Fs or 64x clock is used for phase modu-
lated 64x data (see
Figure 21 ). Use of Phase Modulation Mode may not directly affect the performance of
the CS4385A, but may lower the sensitivity to board-level routing of the DSD data signals.
The CS4385A can detect errors in the DSD data which does not comply with the SACD specification. The
STATIC_DSD and INVALID_DSD bits (Reg. 04h) allow the CS4385A to alter the incoming invalid DSD da-
ta. Depending on the error, the data may either be attenuated or replaced with a muted DSD signal (the
MUTEC pins would be set according to the DAMUTE bit (Reg. 08h)).
More information for any of these register bits can be found in Section 7. “Register Description” on page 37 .
The DSD input structure and analog outputs are designed to handle a nominal 0 dB-SACD (50% modulation
index) at full rated performance. Signals of +3 dB-SACD may be applied for brief periods of time; however;
performance at these levels is not guaranteed. If sustained +3 dB-SACD levels are required, the digital vol-
ume control should be set to -3.0 dB. This same volume control register affects PCM output levels. There
is no need to change the volume control setting between PCM and DSD in order to have the 0dB output
levels match (both 0 dBFS and 0 dB-SACD will output at -3 dB in this case).
 
A Channel
Volume
Control
Aout Ax
AoutBx
Left Chan nel
Audio D ata
Right Chan nel
Audio D ata
B Channel
Volume
Control
MUTE
MUTE
SDINx
Figure 20. ATAPI Block Diagram (x = channel pair 1, 2, 3, or 4)