Cirrus Logic CS5480 - Manual (Page 14)

CS5480
14 DS980F3
SWITCHING CHARACTERISTICS
• Min / Max characteristics and specifications are guaranteed over all Recommended Operating Conditions .
• Typical characteristics and specifications are measured at nominal supply voltages and T
A
= 25°C.
• VDDA = +3.3V ±10%; GNDA = GNDD = 0V. All voltages with respect to 0V.
• Logic Levels: Logic 0 = 0V, Logic 1 = VDDA.
Notes: 13. Specified using 10% and 90% points on waveform of interest. Output loaded with 50pF.
14. Oscillator start-up time varies with crystal parameters. This specification does not apply when using an external clock source.
15. The maximum SCLK is 2 MHz during a byte transaction. The minimum 1µs idle time is required on the SCLK between two
consecutive bytes.
Parameter Symbol Min Typ Max Unit
Rise Times DO1-DO3
(Note 13) Any Digital Output Except DO1-DO3
t
rise
-
- -
50
1.0
-
µs
ns
Fall Times DO1-DO3
(Note 13) Any Digital Output Except DO1-DO3
t
fall
-
- -
50
1.0
-
µs
ns
Start-up
Oscillator Start-up Time
XTAL = 4.096 MHz (Note 14) t
ost
- 60 - ms
SPI Timing
Serial Clock Frequency
(Note 15) SCLK - - 2 MHz
Serial Clock Pulse Width High
Pulse Width Low
t
1
t
2
200
200 -
- -
- ns
ns
CS Enable to SCLK Falling t
3
50 - - ns
Data Set-up Time prior to SCLK Rising t
4
50 - - ns
Data Hold Time After SCLK Rising t
5
100 - - ns
SCLK Rising Prior to CS Disable t
6
1 - - µs
SCLK Falling to New Data Bit t
7
- - 150 ns
CS Rising to SDO Hi-Z t
8
- - 250 ns
UART Timing
CS Enable to RX START bit
t
9
5 - - ns
STOP bit to CS Disable t
10
1 - - µs
CS Disable to TX IDLE Hold Time t
11
- - 250 ns