Vollrath CC404A-Water Cooled User Manual
Page 19
Owner’s Manual #513642
13
CC Model Machines
SECTION 3
INITIAL SET-UP AND OPERATION
3.1 OPERATOR’S SAFETY PRECAUTIONS
SAFE OPERATION IS NO ACCIDENT; observe these
rules:
A.
Know the machine. Read and understand the
Operating Instructions.
B.
Notice all warning labels on the machine.
C.
Wear proper clothing. Avoid loose fi tting garments,
and remove watches, rings or jewelry that could
cause a serious accident.
D.
Maintain a clean work area. Avoid accidents by
cleaning up the area and keeping it clean.
E.
Stay alert at all times. Know which switch, push
button or control you are about to use and what
effect it is going to have.
F.
Disconnect electrical cord for maintenance. Never
attempt to repair or perform maintenance on the
machine until the main electrical power has been
disconnected.
G.
Do not operate under unsafe operating conditions.
Never operate the machine if unusual or excessive
noise or vibration occurs.
3.2 OPERATING CONTROLS AND INDICATORS
Before operating the machine, it is required that the op-
erator know the function of each operating control. Refer
to Figure 3-1 for the location of the operating controls on
the machine.
WARNING
Moving machinery can grab, mangle and dismem-
ber. Place the Freezing Cylinder Off/On switch in
the OFF position before disassembling for cleaning
or servicing.
A.
Hopper Refrigeration OFF-ON Switch
The Hopper Refrigeration OFF-ON switch is a
two-position toggle switch used to supply power
to the the hoppers. When the switch is in the
OFF position, the hopper off light will fl ash. When
the switch is put in the ON position, the hopper
refrigeration system will operate.
Figure 3-1 Machine Controls
IntelliTec Control
(See Figure 3-2)
Hopper
Refrigeration
Off/On
Product
Selector
Switch
Hopper
Off Light
Freezing
Cylinder
Off/On