Konica Minolta bizhub 652 - Manual (Page 11)

Using AU-201H Authentication Unit 3
AU-201H 11
3.2.2 Registering from Data Administrator
In order to use Data Administrator, settings must be specified on the multifunctional
product and the setup procedure must be performed. The setup procedure includes
installing this device’s IC Card Driver (USB-Driver), then installing Data
Administrator IC Card Plugin.
Reminder:
Data Administrator ver. 3.0 or later must first be installed on the computer. For
details on the operating environment and installation procedure for Data
Administrator, refer to the User’s Guide for the Data Administrator.
Setup
1
Turn off the multifunctional product with the main power switch, and then
disconnect this device from the multifunctional product.
2
Install IC Card Driver (USB-Driver).
Plug the cable from this device into the USB port on the computer.
The Found New Hardware Wizard starts.
3
Select “Yes, now and every time I connect a device”, and then click [Next].
4
Insert the application CD-ROM included with this device into the CD-ROM
drive of the computer.